TM 5-5420-227-24
EJECTION CYLINDER REPLACEMENT (LEFT) (Sheet 2 of 4)
5.
Position container to catch hydraulic fluid
in tongue (A).
Tag and mark hose assemblies CA (D),
6.
"CC" (E), and "CB" (F) for identification.
Using 7/8 inch wrench on hose assembly.
7.
nuts and adjustable wrench on elbows
(G, H, J), disconnect hose assemblies
"CA" (D), "CC" (E) and CB (F).
Put protective covering over ends of hose
8.
assemblies "CA" (D), "CC" (E), and "CB" (F).
When removing parts, be sure to keep collars
"CA" (K), "CC" (L), and "CB" (M) with hose
assemblies of same markings.
Using adjustable wrench, remove elbow (G)
9.
and collar "CA" (K) from ejection cylinder
(N) and elbows (H, J) and collars "CC" (L)
and "CB" (M) from tee (P).
10.
Using 3/4 inch wrench on nipple (Q) and
adjustable wrench on tee (P), remove tee
(P) from nipple (Q).
11.
Using 3/4 inch wrench, remove nipple (Q) from
ejection cylinder (N).
12.
Put protective covering on ports of ejection cylinder (N).
13.
Using 1-1/2 inch wrench, remove two
screws (R) and lockwashers (S) from
bottom of tongue (A). Throw lock-
washers (S) away.
14.
Manually remove ejection cylinder (N)
from inside of tongue (A).
15.
Remove container and throw away
drained fluid.
Go on to Sheet 3
3-238