TM 5-5420-227-24
EJECTION CYLINDER REPLACEMENT (RIGHT) (Sheet 2 of 4)
Tag and mark, for identification,
6.
hose assemblies "CA" (D), "CD" (E),
and "CB" (F).
7.
Using 7/8 inch wrench on hose assembly
nuts and adjustable wrench on elbows
(G, H, J), disconnect hose assemblies
"CA" (D) from elbow (G), "CD" (E) from
elbow (H), and "CB" (F) from elbow (J).
8.
Put protective covering over ends of
hose assemblies "CA" (D), "CD" (E
"CB" (F).
When removing parts, make sure to keep
collars "CA" (K), "CD" (L), and "CB" (M)
with hose assemblies of same markings.
Using adjustable wrench, remove elbows
9.
(G, H) and collars "CA" (K) and "CD" (L)
from tee (P) and elbow (J) and collar
"CB" (M) from ejection cylinder.
Using 3/4 inch wrench on nipple (N) and
10.
adjustable wrench on tee (P), remove tee (P),
11.
Using 3/4 inch wrench, remove nipple (N).
12.
Put protective covering on ports of ejection
cylinder (Q).
13.
Using 1-1/2 inch wrench, remove two
screws (R) and lockwashers (S) from"
bottom of tongue (A). Throw
lockwashers (S) away.
14.
Manually remove ejection cylinder (Q).
15.
Remove container and throw away drained
fluid.
G O on to Sheet 3
3-242