TM 5-5420-202-20-3
ELECTRICAL WIRING HARNESS AND CABLE CONNECTOR REPAIR (Sheet 12 of 18)
Female Plug Repair (Sheet 2 of 3)
Using diagonal cutting pliers, cut
5.
wire from contact (E). Throw away
contact (E).
6.
Pulling cut wire out of grommet (D),
use diagonal cutting pliers to shorten
wire about 6 inches. Fasten new end
of cut wire to cable (C) and wrap
with friction tape.
Using hand wire stripper, strip insulation
from jumper wire equal to depth of contact
solder well (F).
Placing connector
face down on flat
s u r f a c e , apply a
small amount of silicone
to empty holes on
back of plug assembly
(B) and on front
of grommet (D).
Push new contact (E) into hole in back of
9.
plug assembly (B) far enough so it will
remain standing.
Push jumper wire end, first through
10.
grommet retaining nut (A) and then
through hole in grommet (D).
TA249250
Go on to Sheet 3
10-309