TM 5-5420-202-20-3
ELECTRICAL WIRING HARNESS AND CABLE CONNECTOR REPAIR (Sheet 15 of 18)
Female Connector With Sleeve (14 and 16 Gauge Cable) Repair (Sheet 1 of 1)
Electrical connector repair tool kit
TOOLS:
Diagonal cutting pliers
SUPPLIES:
Silicone compound (Item 32, Appendix D)
Disconnect three battery ground straps (page 10-268)
PRELIMINARY
PROCEDURES:
Loosen or remove cable clamps as required
Slide shell (A) and sleeve (B)
1.
back along cable (C).
2. Using diagonal cutting pliers, cut
terminal (D) from cable (C).
Throw teriminal (D) away.
Using hand wire stripper, strip
3.
insulation from cable (C) equal
to well depth in terminal (D).
4.
Insert stripped cable end (E)
into well in terminal (D).
5.
Using crimping tool, crimp terminal (D).
6.
Slide sleeve (B) forward along cable (C)
until tight against terminal (D).
7.
Slide shell (A) forward along cable (C) until tight against sleeve (B).
8. Using multimeter, check continuity of repair circuit.
9. Tighten or install cable clamps as required.
10. Connect three battery ground straps (page 10-268).
TA249253
End of Task