TM 5-5420-202-20-3
ELECTRICAL WIRING HARNESS AND CABLE CONNECTOR REPAIR (Sheet 13 of 18)
Female Plug Repair (Sheet 3 of 3)
Hold jumper wire so wire end is pushing
11.
down on solder in contact solder well (F).
Holding soldering gun tip against side of
12.
contact (E) until solder begins to melt
and wire slips into contact solder well (F).
Removing soldering gun from side of
13.
contact (E), continue holding wire until
solder has cooled and set.
14. Using remover, push contact (E) into
plug assembly (B).
Sliding grommet (D) forward along cable
15.
(C), set grommet (D) firmly against
contacts (E).
Manually thread grommet retaining nut (A)
16.
onto plug assembly (B).
Using multimeter, check continuity of
17.
repaired circuit.
Tighten or install cable clamps as required.
18.
Connect connectors at each end of
19.
affected cable.
20.
Connect three battery ground straps (page
End of Task
TA249251
10-310