TM 5-5420-202-20-3
ELECTRICAL WIRING HARNESS AND CABLE CONNECTOR REPAIR (Sheet 9 of 18)
Female Plug Repair (Sheet 2 of 3)
Using diagonal cutting pliers, cut wire
5.
from contact (E). Throw away contact (E).
Pulling cut wire out of grommet (D), use
6.
diagonal cutting pliers to shorten wire
about 6 inches. Fasten new end of cut wire
to cable (C) and wrap with friction tape.
7. Using hand wire stripper, strip insulation
from jumper wire equal to depth of contact
solder well (F).
Placing connector face down on flat
8.
surface, apply a small amount of silicone
to empty holes on back of plug assembly
(B) and on front of grommet (D).
Push new contact (E) into hole in back of
9.
plug assembly (B) far enough so it will
remain standing.
10.
Push jumper wire end, first through
grommet retaining nut (A) and then
through hole in grommet (D).
TA249247
Go on to Sheet 3
10-306