TM 5-5420-202-20-3
ELECTRICAL WIRING HARNESS AND CABLE CONNECTOR REPAIR (Sheet 10 of 18)
Female Plug Repair (Sheet 3 of 3)
11. Hold jumper wire so wire end is pushing
solder in contact solder well (F).
down on
Hold soldering gun tip against side of
12.
contact (E) until solder begins to melt
and wire slips into contact solder well (F).
Removing soldering gun from side of
13.
contact (E), continue holding wire until
solder has cooled and set.
14.
Using remover, push contact (E)
into plug assembly (B).
Sliding grommet (D) forward along cable
15.
(C), set grommet (D) firmly against
contacts (E).
Manually thread grommet retaining nut (A)
16.
onto plug assembly (B).
17.
Using multimeter, check continuity of repaired circuit.
Tighten or install cable clamps as required.
18.
19.
Connect connectors at each end of affected cable.
20.
Connect three battery ground straps (page 10-268).
End of Task
TA249248
10-307