TM 5-5420-202-20-3
SHIFT LINKAGE ADJUSTMENT (Sheet 5 of 28)
10.
Using 9/16 inch wrench, loosen jamnuts
(P) and (Q).
11.
Using 9/16 inch wrench, remove screw (R).
Using hands move shifting rod (S)
12.
and insert locating pin (L) into
alinement holes in bracket (M) and
link (N).
13.
Using 9/16 inch wrench, adjust shifting rod bearing end (T) by turning clockwise or
counterclockwise until screw (R) will slip freely through link (U) and shifting rod bearing
end (T).
14.
Using small diameter wire, check to see if shifting rod (S) is past witness holes (V) and
(W). If shifting rod (S) is past holes (V) and (W), do steps 15 thru 18. If shifting rod
(S) is not past hole (W), do steps 19 thru 28. If shifting rod (S) is not past hole (V) go
to step 29.
TA249322
Go on to Sheet 6
11-56