TM 5-5420-202-20-3
SHIFT LINKAGE ADJUSTMENT (Sheet 12 of 28)
58.
Using 9/16 inch wrench, remove screw (AM).
59.
Using 9/16 inch wrench, adjust shifting
rod bearing end (AL) by turning clockwise
until shifting rod (AH) is past hole (AK).
60.
Using 9/16 inch wrench, install screw (AM).
61.
Holding rod
bearing end (AL) with 9/16 inch
wrench, use
torque wrench and 9/16 inch crow-
foot adapter
to tighten jamnut (AE) to 16-18
lb-ft (22-24
Nm).
62.
Using torque wrench and 9/16 inch socket,
tighten screw (AM) to 16-18 lb-ft (22-24 Nm).
63.
Using 9/16 inch wrench, adjust shifting rod
bearing end (AG) by turning clockwise or
counterclockwise until screw (AF) will drop
freely through clevis (AC) and shifting rod
bearing end (AG).
Using 9/16 inch wrench, install screw (AF).
64.
Holding rod, bearing end (AG) with 9/16 inch wrench, use torque wrench and 9/16 inch
65.
crowfoot adapter to tighten jamnut (AD) to 16-18 lb-ft (22-24 Nm).
66.
Using torque wrench and 9/16 inch socket, tighten screw (AF).
Go on to Sheet 13
TA249329
11-63
