TM 5-5420-202-20-3
SHIFT LINKAGE ADJUSTMENT (Sheet 19 of 28)
RIGHT REAR OF
ENGINE COMPARTMENT
97.
Using 9/16 inch wrench, remove screw (AZ).
NOTE
Do not allow shifting rod (66) to turn while doing step 98.
Shifting rod (66) is made up of more than one piece and
may come apart if allowed to turn.
Using 9/16 inch wrench, adjust shifting rod
98.
bearing rod end (BC) by turning clockwise
or counterclockwise, until screw (AZ) will
drop freely through clevis (BA) and shifting
rod bearing end (BC).
Using 9/16 inch wrench, install screw (AZ).
99.
Holding rod bearing end (BC) with 9/16 inch wrench, use torque wrench and 9/16 inch
100.
crow foot adapter to tighten jamnut (AX) to 16-18 lb-ft (22-24 Nm).
Remove locating pin (AU) from alinement holes.
101.
102.
Using torque wrench and 9/16 inch socket, tighten screw (AZ) to 16-18 lb-ft (22-24 Nm).
TA249336
Go on to Sheet 20
11-70