TM 5-5420-202-20-3
MECHANICAL TRACK ADJUSTING LINK REPLACEMENT (Sheet 1 of 5)
PROCEDURE INDEX
PAGE
PROCEDURE
Removal
Installation
TOOLS: Slip joint pliers
Ratchet with 3/4 in. drive
3/4 in. socket wit 3/4 in. drive
1-1/8 in. socket with 3/4 in. drive
Pry bar
Wire brush
Soft mallet
Slide hammer puller (5573615)
SPECIAL TOOLS: Roadwheel adapter (Item 9, Chapter 3, Section I)
Cotter pins (2 required)
SUPPLIES:
Rags (Item 65, Appendix D)
Lockwashers (2 required)
Three
PERSONNEL:
REFERENCE:
Disconnect track (TM 5-5420-202-10
PRELIMINARY PROCEDURES:
Remove front fender (page 16-58)
NOTE
This adjusting link replacement procedure is for left side of
vehicle. Right side adjusting link procedure is similar.
Go on to Sheet 2