TM 5-5420-202-34
SHIFTING CONTROL ROD ASSEMBLY REPLACEMENT (Sheet 1 of 2)
TOOLS:
1-1/2 lb. hammer
1/4 in. drive punch
9/16 in. combination box and open end wrench (2 required)
9 / 1 6 in. crowfoot wrench with 1/2 in. drive
9/16 in. socket with 1/2 in. drive
Torque wrench with 1/2 in. drive (0-200 lb-in) (0-23 Nm)
Vise
SUPPLIES:
Pins
REFERENCE:
T M 5-5420-202-20
PRELIMINARY PROCEDURE:
Remove right fuel tank (page 4-9)
REMOVAL:
Using hammer and punch, remove pin (A) from universal joint (B). Throw pin (A) away.
1.
Using 9/16 inch wrench, remove screw (C) from rod end (D).
2.
3.
Pull rod end (D) from clevis (E).
4.
Remove shaft (F) from rod (G).
5.
Hold shaft (F) in vise. Using hammer and punch, remove pin (H) from universal joint
(J). Throw pin (H) away.
6.
Remove shaft (F) from universal joint (J).
7.
Using 9/16 inch wrench to hold nut (K), use 9/16 inch wrench to remove rod end (D)
from shaft (F).
8.
Using 9/16 inch wrench, remove nut (K) from shaft (F). Remove shaft (F) from vise.
Go on to Sheet 2