TM 5-5420-202-34
REAR SHIFTING LINKAGE SHIELD ASSEMBLY REPAIR (Sheet 2 of 3)
DISASSEMBLY:
1.
Put shield (A) in vise (or hold shield)
with smaller end up.
2.
Insert 51 inch long knockout rod through
opening at smaller end of shield (A).
3.
Using hammer, tap knockout rod to
drive out seal (B), bearing (C), and inner
seal (D).
INSPECTION:
Inspect shield for cracks, bends, or other
damage.
ASSEMBLY:
1.
Position shield (A) in vise (or on ground)
with larger end up.
2.
Place inner seal (B) in larger end of
shield (A).
3.
Insert 12 inch long knockout rod into
larger end of shield (A). Using hammer,
tap rod to drive seal (B) in as far as
it will go.
Go on to Sheet 3
6-12