TM 5-5420-202-34
REAR SHIFTING LINKAGE SHIELD ASSEMBLY REPAIR (Sheet 3 of 3)
Position bearing (C) in shield (A).
4.
5.
Insert 12 inch long knockout rod to larger
end of shield (A).
6.
Using hammer, tap rod to drive bearing
(C) in as far as it will go.
Place outer seal (D) in shield (A).
7.
8.
Insert 12 inch long knockout rod, and
using hammer, tap rod to drive seal
(D) in as far as it will go.
INSTALLATION:
Slide shield (A) over shifting control rod (B).
1.
2.
Aline pins of front shield (A) to slot of rear shield (C).
3.
Push shield (A) all the way forward.
4.
Install support straps (page 6-15).
5.
Install right fuel tank (page 4-17).
End of Task
