TM 5-5420-226-20-2
TURBOSUPERCHARGER OIL DRAIN TUBE (RIGHT BANK) REPLACEMENT
(sheet 1 of 4)
PROCEDURE INDEX
PROCEDURE
PAGE
Removal
Inspection
Installation
TOOLS: 1/2 in. socket with 1/2 in. drive
Ratchet with 1/2 in. drive
Flat-tip screwdriver
SPECIAL TOOLS: Ground hop kit
SUPPLIES:
Hose
Lubricating oil (MIL-L-2104)
Gasket
REFERENCES:
PRELIMINARY PROCEDURES:
Remove powerplant (page 5-2)
Drain engine oil (page 6-12)
Remove generator (page 10-6)
NOTE
If clamp (A) cannot be loosened with
screwdriver, use 5/1 6-inch combination
box and open end wrench.
1.
Using screwdriver, loosen six clamps (A) on three hoses (B) on each end of upper drain tube.
Go on to Sheet 2
TA107559