TM 5-5420-226-20-2
ACCELERATOR LINKAGE ADJUSTMENT (Sheet 3 of 6)
Insert 1/8 inch diameter locating pin (L)
9.
through alinement hole of remote control
lever (M). If locating pin cannot be
inserted, perform steps 10 thru 16. If
locating pin can be inserted, go to step 16.
10.
Using 7/16 inch wrench to hold rod end
bearing (N) (on flats), use 1/2 inch
wrench to loosen nut (P).
Using 7/16 inch wrench, remove screw (Q).
11.
12.
Insert locating pin (L) through alinement
hole into housing (R).
NOTE
If rod (N) cannot be adjusted short
enough for screw (Q) to slip freely
through lever (M), push rod (N)
forward and insert screw (Q).
13.
Turn rod end bearing (N) until screw (Q)
slips freely through remote control lever
(M) and rod end bearing.
14.
Using 7/16 inch wrench to hold rod end
bearing (N), tighten nut (P).
15.
Using 7/16 inch wrench, tighten screw (Q).
16.
Remove locating pin (L).
Go on to Sheet 4
TA108046