TM 5-5420-226-20-2
TRANSMISSION SHROUDS REPLACEMENT (Sheet 6 of 8)
Lower Shroud Replacement (Sheet 1 of 2)
TOOLS:
1/2 in. socket with 1/2 in. drive
Ratchet with 1/2 in. drive
1/2 in. combination box and open end wrench
6 in. flat-tip screwdriver
2 in. flat-tip screwdriver
Remove powerplant (page 5-2).
PRELIMINARY PROCEDURES:
Remove engine shroud (page 9-30).
(right side only).
NOTE
NOTE
When lower shroud is removed, a grommet
Replacement of right and left lower shrouds
(G) may come out with it or stay on fuel
(A) is similar. Left lower shroud (A) is shown.
return 1 inc.
REMOVAL:
Using 2 inch screwdriver, remove screw
1.
(B).
Using 6 inch screwdriver, remove screw
2.
(c).
Using socket or wrench, remove three
3.
screws and washers (D).
Using socket or wrench, remove screw
4.
and washer (E) securing clamp (F).
Remove lower shroud (A). Be careful
5.
not to damage fuel return line when
removing shroud (A).
Inspect grommet (G) for tears or deterioration.
6.
Relace-if defective.
TA107982
G O on to Sheet 2